DOOR / HATCH: BACK DOOR: ADJUSTMENT (2008 Sequoia)

Last Modified: 11-29-2007		1.6 N
Service Category: Vehicle Exterior	Section: Door/Hatch
Model Year: 2008	Model: Sequoia	Doc ID: RM000001ENT00SX
Title: DOOR / HATCH: BACK DOOR: ADJUSTMENT (2008 Sequoia)

ADJUSTMENT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing .

HINT:

Centering bolts are used to mount the door hinge onto the vehicle body and door. The door cannot be adjusted with the centering bolts in. Substitute standard bolts (with washers) for the centering bolts when making adjustments.
For bolts without torque specifications, check the standard bolt chart .

1. INSPECT BACK DOOR

(a) Check that the clearance measurements are within the standard ranges.

Standard:

Area	Measurement	Area	Measurement
A	11.9 mm (0.469 in.)	F	0.2 mm (0.008 in.)
B	1.6 mm (0.063 in.)	G	6.0 mm (0.236 in.)
C	8.0 mm (0.315 in.)	H	0 mm (0 in.)
D	2.1 mm (0.083 in.)	I	15.1 mm (0.594 in.)
E	6.6 mm (0.260 in.)	-	-

2. ADJUST BACK DOOR

(a) Disconnect the cable from the negative battery terminal.

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing .

(b) Adjust the door position.

(1) Horizontally and vertically adjust the door by loosening the door side hinge bolts.

Torque: 20 N·m (199 kgf·cm, 14 ft·lbf)

(1) Using "TORX" socket wrench T40, adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a plastic-faced hammer.

(2) Using "TORX" socket wrench T40, tighten the striker mounting screws after the adjustment.

Torque: 27 N·m (275 kgf·cm, 20 ft·lbf)

(d) Connect the cable to the negative battery terminal.

Torque: 5.4 N·m (55 kgf·cm, 48 in·lbf)

CAUTION:

When disconnecting the cable some systems need to be initialized after the cable is reconnected .

(e) Inspect the SRS warning light .